Very few solid substrates will permanently adhere to a Teflon finish.Although tacky materials may show some adhesion, almost all substances release easily.
Low coefficient of friction:
The co-efficient of friction of Teflon is very low generally in the range of 0.05 to 0.20 depending on the load, sliding speed and particular Teflon coating used.
Non wetting :
Since surfaces coated with Teflon are both oleo-phobic & hydrophobic, they are not readily wet. Clean up easier and more through - in many coats, surfaces are self cleaning.
Teflon Industrial Coatings can operate continuously at temperature -70oC upto 290oC1550oF & can be used for intermittent service upto 315oC/ 1600o F with adequate verification.
Unique electrical properties:
Over a wide range of frequencies Teflon has high dielectric strength, low dissipation factor & very high surface resistivity. By special techniques it can even be made electro conductive enough to be used as an antistatic coating.
Teflon Industrial coatings withstand severe temperature extremes without loss of physical properties. Teflon industrial coating may be considered for use at temperature as low as- 270oC / 454oF.
Teflon is normally unaffected by chemical environments such as resin, paint and chemical medicine. The only chemicals known to affect all Teflon industrial coatings are molten alkali metals & highly reactive fluorinating agents.
Belts for Fusing machines:
Common seam fusing machine belt:
Seam fusing machine belt uses the entire imported base material from to weave. The surface is smooth and lustrous and the price is competitive. Made of High quality imported fabric, these provide for an impression free fusing transfer.
2 Ply fusing machine belt:
Seam Double Deck Compound Fusing Machine belt (AA) is made of imported material. This product has super resistance to tearing and static, with static-resistance varnished cloth inside and tearing-resistance fiberglass cloth outside, 2ply belt has a great improvement on its intensity, long using life, well balanced thickness, excellent deflecting preventing capacity, smooth surface, it's better for super thin fabric fusing.
PTFE seamless fusing machine belt:
The belt is made of high tensile fiberglass or Kevlar, knitted by special equipment and coated with fine PTFE. Seamless belt overcomes former problems of traditional joint fusing machine belt such as bad stability, ruptures, and deflecting for different girth on two sides at the joint. The using life of seamless PTFE Fusing Machine Belt are much longer than all kinds of joint PTFE Fusing Machine Belt.
Reply to this Ad
Tell Us Your Requirement